ANITA ©
25
4.20) Wiper Adjustment
1. GF-1117-447 H
Turn the pulley manually and stop when the white carved signs on the arm and the pulley are
aligned. (Highest point of the thread take up lever.) Loosen the two wiper shaft fixing screws (1) on
the wiper base and press the connecting link (2) with the hand. Then adjust the wiper shaft (3) so that
the gap between the wiper and the needle is about 2mm and tighten the wiper shaft fixing screw (1).
Next, loosen the wiper fixing screw (4) and adjust so that the gap between the lower end of the wiper
and the end of the needle is about 2mm, after which the wiper fixing screw (4) must be tightly
fastened. (See Fig. 41 & 42)
(Fig 41 & 42)
2. GF-1116-147LM / GF-1118-147LM series
Set the stitch length adjusting dial to "2".
Turn the pulley manually and stop when the white carved signs on the arm and pulley are in a straight
line. (Highest point of the thread take up lever). At this point, position the wiper so that the needle and
the presser foot are about 2mm apart and then fix the position. (See Fig.43)
(Fig. 43)
Summary of Contents for GF-1116 Series
Page 30: ...ANITA 30...
