Garmin SOCATA TBM850, Pilot'S Manual

Page: 643 / 684

190-00709-04 Rev. A
Garmin G1000 Pilot’s Guide for the Socata TBM 850
629
APPENDIX A
GCU 475 MESSAGE ADVISORIES
Message Comments
GCU CNFG – GCU Config error.
Config service req’d.
GCU 475 configuration settings do not match those of backup configuration memory.
The G1000 system should be serviced.
GCU FAIL – GCU is inoperative. A failure has been detected in the GCU 475. The GCU 475 is unavailable.
MANIFEST – GCU software mismatch,
communication halted.
The GCU 475 has incorrect software installed. The G1000 system should be serviced.
GCU KEYSTK
– GCU [key name] Key
is stuck.
A key is stuck on the GCU 475 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.
GMC 710 MESSAGE ADVISORIES
Message Comments
GMC CONFIG
– GMC Config error.
Config service req’d.
Error in the configuration of the GMC 710.
GMC FAIL – GMC is inoperative. A failure has been detected in the GMC 710. The GMC 710 is unavailable.
MANIFEST – GMC software
mismatch. Communication halted.
The GMC 710 has incorrect software installed. The G1000 system should be serviced.
GMC KEYSTK
– GMC [key name] Key
is stuck.
A key is stuck on the GMC 710 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.
MISCELLANEOUS MESSAGE ADVISORIES
Message Comments
FPL WPT LOCK – Flight plan waypoint
is locked.
Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an navigation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this message.
This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
Or
update the waypoint name/identifier to reflect the new information.
FPL WPT MOVE
– Flight plan
waypoint moved.
The system has detected that a waypoint coordinate has changed due to a new
navigation database update. Verify that stored flight plans contain correct waypoint
locations.
TIMER EXPIRD – Timer has expired. The system notifies the pilot that the timer has expired.
MISCELLANEOUS MESSAGE ADVISORIES (CONT.)
Message Comments
DB CHANGE – Database changed.
Verify user modified procedures.
This occurs when a stored flight plan contains procedures that have been manually
edited. This alert is issued only after an navigation database update. Verify that the
user-modified procedures in stored flight plans are correct and up to date.
DB CHANGE
– Database changed.
Verify stored airways.
This occurs when a stored flight plan contains an airway that is no longer consistent
with the navigation database. This alert is issued only after an navigation database
update. Verify use of airways in stored flight plans and reload airways as needed.