Garland HEEGM XX CL, Installation And Operation Manual

Page: 6 / 32

Part # 4530868 (04/25/12) Page 6
PRE INSTALLATION
IT IS STRONGLY RECOMMENDED THAT INSTALLATION,
MAINTENANCE AND REPAIRS BE DONE BY AN AUTHORIZED
SERVICE AGENCY. FOR A LIST OF AUTHORIZED SERVICE
AGENTS, REFER TO THE GARLAND WEB SITE AT http://www.
garland-group.com
Introduction
Garland manufactures the HEEGM series broiler in several
sizes. While service and customer operation may vary
from size to size, installation is similar for each. All units are
shipped fully assembled, except for the radiants and top
grates, which are packaged in separate boxes. Each unit
is tested, adjusted and inspected at the factory prior to
shipment.
Damage Check
After unpacking the unit, be sure to carefully inspect the unit
for visible and/or concealed damage. Report any damage
immediately to your carrier to file the appropriate freight
claims.
Rating Plate
The rating plate can be found on the inside face of the left
leg. The grease drawer may need to be removed in order
to read the information. If service or replacement parts
are needed, refer to the model number (including prefix &
suffix letters/numbers) and serial number on the rating plate
when contacting the factory or authorized service agency.
These numbers ensure proper unit identification and aid in
providing faster and more accurate service.
The rating plate contains other important information critical
to the proper installation of the unit. It specifies the gas type;
gas pressure; voltage and clearance requirements for the
appliance.
INSTALLATION
THIS PRODUCT IS NOT AUTHORIZED FOR HOME OR
RESIDENTIAL USE. GARLAND WILL NOT PROVIDE SERVICE,
WARRANTY, MAINTENANCE OR SUPPORT OF ANY KIND
OTHER THAN IN COMMERCIAL APPLICATIONS.
General
In the United States, installation of this appliance must
conform to the National Fuel Gas Code ANSI Z223.1, or latest
edition, NFPA No.54-latest edition/or local code to assure
safe and efficient operation.
In Canada, installation of this appliance must comply with
CSA B149.1 and local codes.
In other countries, installation must be carried out by
a competent person, in accordance with the relevant
regulations; codes of practice and the related publications of
the country of destination.
If you have any questions regarding the installation of this
unit, contact the Garland Service Department at (800) 427-
6668 or online at http://www.garland-group.com
Positioning and Setup
1. Carefully remove the unit from the crate base. Some
form of mechanical assistance may be required to lift and
position the broiler. With the grease drawers removed,
the unit is designed to be lifted with a pallet or lift jack as
shown in the image below.
TRAY SLIDES
FORKS
DO NOT LIFT BY GREASE DRAWER SLIDES. CARE SHOULD BE
TAKEN TO AVOID THE LEFT, RIGHT AND/OR CENTER GREASE
DRAWER SLIDES WHEN POSITIONING LIFTING EQUIPMENT.