USER GUIDE
EdgeSafe 10G Modular Bypass | Firmware Rev Level: 0.3.3.2
6.50 Show/Set snmp traps enable state. (show/set_trap)
SNMP traps can be enabled or disabled from CLI interface by using set_trap command.
Default – all traps disabled.
Command SHOWs several parameters:
set_trap [trap,..] trap new_state
●
new_state – on/off
●
trap –
○
appl - application state change trap.
○
bp - bypass state change trap.
○
mon - monitor ports state change trap.
○
net - network ports state change trap.
○
term - terminal port state change trap.
○
error - error happened trap, power supply restored, CPU fan restored.
○
update - update finished trap.
○
all - all traps.
SNMP trap enable state can be obtained by the show_en_trap command. Command does not
Show parameters.
Garland Technology | 716.242.8500 |
60