![background image](http://html1.mh-extra.com/html/gardner-denver/integra-efa99f/integra-efa99f_operating-and-service-manual_563798053.webp)
13-8-639 Page 53
COMPRESSOR OIL FILTER
(Figure 5-1, page 45and Figure 5-7, page 54)
-
This replaceable element
filter is a vital part in maintaining a trouble-free compressor, since it removes dirt and abrasives from the
circulated oil.
CAUTION
Improper oil filter maintenance will cause damage to equipment. Replace filter
element every 1000 hours of operation. More frequent replacement could be
required depending on operating conditions. A filter element left in service too
long may damage equipment.
Use only the replacement element shown on the filter tag or refer to the Parts List for the part number.
Use the following procedure to replace the filter element. Do not disturb the piping.
DANGER
Air/oil under pressure will cause severe personal injury or death. Shut down
compressor, relieve system of all pressure, disconnect, lockout and tagout
power supply to the starter before removing valves, caps, plugs, fittings, bolts
and filters.
DANGER
Compressor, air/oil reservoir, separation chamber and all piping and tubing
may be at high temperature during and after operation.
1. Stop unit and be sure no air pressure is in the oil reservoir.
2. Disconnect, lockout and tagout the power supply to the starter.
3. Remove the spin-on element.
4. Clean the gasket face of the filter body.
5. Coat the new element gasket with clean lubricant used in the unit.
6. Screw new element on filter body and tighten clockwise by hand 3/4 turn after contact. DO NOT
OVERTIGHTEN ELEMENT.
7. Reset the filter life setting to 1000 hours, see “SERVICE MENU, Section 4, page 32.
8. Run the unit and check for leaks.
Summary of Contents for INTEGRA EFA99F
