13-8-639 Page 24
DANGER
The compressor starts and stops automatically. Automatic restarting can
cause injury or death. Open, lockout and tagout main disconnect and any other
circuits before servicing the unit.
CAUTION
The enclosure doors are connected to a shutdown switch that will not allow the
compressor to operate without the complete enclosure in place.
STARTING THE UNIT
- Observe the following starting procedures:
WARNING
After an emergency stop, be sure that the pressure in the air/oil reservoir is less
than 5 psig. Wait one minute or more before restarting.
WARNING
The controller has an automatic start/stop sequence built in. You do NOT need
to close the air service valve. Closing the air service valve on start-up or prior
to shutdown will cause rapid cycling, and could cause a high pressure
shutdown.
1. Turn the customer supplied main switch on.
2. Push the Start button.
DAILY CHECK
- Refer to “Maintenance Schedule,” Section 8, page 63.
STOPPING THE UNIT
:
1. Push the Stop button.
2. Wait approximately one minute to allow the compressor to stop.
3. Turn the customer supplied main switch off.
EMERGENCY STOP
– The compressor stops when the Emergency Stop button is pushed.
To restart the compressor, wait one (1) minute after Emergency Stop, then turn the Emergency Stop
button clockwise to release it. Start the compressor per the instructions above. If an alarm has been set,
press the Reset button before starting.
Summary of Contents for INTEGRA EFA99F
