196cc 4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
(toll free)
MODEL No.: SLM462 • 03/2019 63158
e-mail: [email protected]
AUS
37
1300 889 028
AUS
Deck wash
The deck wash feature allows you to wash/clean the underside of the
lawn mower deck using a standard garden hose fitting.
WARNING! It is recommended to wear gloves during this
process so as to not risk any personal injury from the
blades when cleaning the underside of the deck.
1) Position mower on a flat and level section of grass, which will not
cause problems if the grass and surrounding area will get wet.
NOTE:
It is NOT recommended to perform this operation on a
concrete surface as the concrete may be stained.
2) Remove the catcher (17) and ensure the rear discharge guard (7) is
closed.
3) Attach a standard quick connect garden hose fitting (not supplied)
to the deck wash nozzle (25).
NOTE:
If you do not have a standard garden hose fitting, use the
supplied standard hose fitting (47) to connect to your garden hose.
4) Raise the deck height to approximately mid height using the height
adjustment lever (16).
5) Start the lawn mower and run at a low speed.
6) Turn on the water at the tap, then increase the speed of the lawn
mower so as to distribute the water under the entire deck.
7) Run the process with the water running for approx 5 min or shorter
if no more grass is washing out from under the deck and then turn
off the water. Continue to run the lawn mower at medium speed for
a few minutes to assist in drying out the under deck.
8) Turn off the lawn mower and remove the standard hose fitting from
the deck wash nozzle.
Damaged cutting blades
If, in spite of all caution, if the cutting blades
come into contact with an obstacle, switch off the
engine immediately and pull the spark plug cover.
Tilt the mower to the side and check the cutting
blades for damage. Damaged or bent cutting
blades must be replaced. Never straighten a bent
cutting blade. Never work with bent or heavily
Maintenance
L1
38
46
45
