196cc 4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
(toll free)
MODEL No.: SLM462 • 03/2019 63158
e-mail: [email protected]
AUS
21
1300 889 028
AUS
Assembly
Assembly
WARNING:
Stop the engine and unplug the spark plug before any
repairs or maintenance operations.
WARNING:
DO NOT attempt to start this mower without first adding
600ml of SAE 10W/30 engine oil to the engine.
WARNING:
Do not attempt to start this mower without the mower
first being FULLY assembled.
It is necessary to fit the lower handle (5), upper handle (4), and catcher (17).
Preparing for assembly
NOTE:
When preparing for this assembly, remove the upper and lower
handle bars from the box ensuring the cables do not become tangled or
crossed over. Damage to the cables can affect performance of the engine.
After removing from the packaging box, lay the handles in position for
assembly. The electric start cable and the engine variable speed cable need
to be aligned down the left hand side of the handles
(when looking at the mower from the front). The start
cable needs to be aligned down the right hand side of
the mower. Ensure during assembly all the cables are laid
above the handles not on the underside of the handles.
Use the cable clips to secure the cables onto the handles.
1. ASSEMBLY OF THE HANDLES (See Fig. A1-
A5)
1) Insert the lower handle (5) ends into the holes
on the rear of the deck. (See Fig. A1)
2) Insert the supplied assembly screw/s into the
screw hole/s on each side of the deck and
tighten the screws in a clockwise direction
using the supplied spark plug spanner /
combination screwdriver (30). (See Fig. A2)
3) Place the upper handle(4) ends onto the outer
sides of the lower handle (5) bar as shown in
A1
A2
