196cc 4 Stroke Petrol Lawn Mower
AFTER SALES SUPPORT
(toll free)
MODEL No.: SLM462 • 03/2019 63158
e-mail: [email protected]
AUS
26
1300 889 028
AUS
covered under the warranty of the lawn mower.
Each time the lawn mower is used, the oil level should be checked. If
low, add sufficient oil to ensure the oil level is to the full mark on the
dipstick.
1) Position the lawn mower on a flat and level surface. Clean the area
directly around the oil tank / dipstick (14).
2) Remove the oil dipstick (14) by turning it in an anti-clockwise
direction. Clean the oil tank dipstick (14) with a clean cloth, cleaning
away any visual oil.
3) For a new lawn mower, add 600ml of 4 stroke SAE 10W/30 engine
oil.
4) Insert the oil dipstick (14) back and secure it by turning in a
clockwise direction.
5) To check the oil level again, remove the oil
dipstick (14). It should be at the top of the full
(max) indicator on the dipstick. (See Fig. F2)
6) If low, add oil slowly into the oil sump. Do not
overfill. After adding oil, wait one minute and
then recheck the oil level.
7) Replace and tighten the oil dipstick (14). Always
ensure the oil dipstick (14) is firmly locked in
place before the engine is started.
NOTE:
●
Do not allow engine to run low on oil as it will reduce the life of the
engine.
●
Do not over fill with oil above the full indicator mark.
3. FUELLING (See Fig. G1, G2)
WARNING!
●
To prevent engine damage, the engine is
shipped without fuel. The engine must be
filled with the correct grade of fuel before
starting the engine.
●
Do not refill the fuel tank while engine is
Assembly
G1
F2
max
