S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
43669
20
It is not necessary to remove the bag from the vac machine, but if it is preferred,
you need to remove the two retaining screws on the vac outlet tube and rotate
the tube off the vac housing.
With the bag assembly on or off the vac, open the zip on the bottom edge of the
bag, and empty the contents from the bag. It is suggested to give the bag a good
shake to dislodge as much dust as possible.
Check the teeth on the zip are not clogged or fouled with debris. Close the zip
fully. Replace the bag assembly on to the vac outlet if the bag was removed.
Maintenance
WARNING.
Before performing any
maintenance on this blower, stop the
engine and disconnect the spark plug wire.
Checking the spark plug
Check the spark plug every 10 - 15 hours
of use.
1. Remove the spark plug cover.
2. Use the spark plug wrench to remove
the spark plug, by turning it counter-
clockwise.
3. Clean and adjust the spark plug gap to 0.6
- 0.7mm. Replace any damaged or visibly
worn plug with a CHAMPION RCJ6Y, NGK
BPM6A or equivalent spark plug.
4. Install the spark plug finger tight in the cylinder head, then tighten it firmly with
the spark plug wrench.
Note.
If your spark plug becomes worn replacements are available for purchase.
Please refer to page 23 for
further detail.
Instructions
5