S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
43669
12
6. Screw the tubes together using the screws provided.
Check the intake cover. For using the blower vac as a blower,
the vac tubes should not be fitted, but the intake cover MUST
be closed and secured with the supplied screw.
The blower vac is now ready for use as a blower.
Note.
The vac tubes and the collection bag are not required
for the blower operation.
Setting up for use as a vac
Assembly of the vac tubes
1. Align the lower vac tube and the vac tube
nozzle and slide the vac tube inside the vac
tube nozzle until it will enter no more.
2. Rotate the two tubes and lock them
together.
3. Fix the two tubes together with the supplied assembly screws.
Fitting the vac tube to the blower vac housing
1. Using a Phillips type screw driver loosen and remove the
single assembly screw
in the intake cover.
2. Open the intake cover
and insert the vac
tube so it fits inside
the round entry of
the vac housing. It is
important to locate
the square tab of the vac tube under and into the locating
keyway as the vac tube is fitted. (Refer to pic)
3. Secure the tube in place with the screw previously removed
from the inlet cover.
Instructions
5