G&D VisionXS-IP-F-DP-UHR, Installation And Operation Manual

Page: 139 / 232

Start-up
G&D VisionXS-IP-F-DP-UHR · 18
English
Start-up
After the proper installation of the KVM extenders they can be immediately put into
operation.
Mind the following activation sequence when starting the modules:
1. Switch on the external power supply of the
console module
or
switch on the internal power supply (DT variants only).
2. Switch on the external power supply of the
computer module
or
switch on the internal power supply (DT variants only).
3. Turn on the
computer
that is connected to the computer module.
Starting process
After the computer module and the console module are turned on, the LEDs on the
back panel show the module’s operating status.
For further information about this topic, also see the chapter Status LEDs on
page 99 ff.
Operation
You can operate the computer connected to the
VisionXS-IP-CPU
computer module at
the remote console of the console module.
NOTE: The recommended activation sequence ensures that the KVM extenders
are able to read out the features of the connected monitor and to transmit them to
the computer (see DDC transmission with cache function on page 95).
IMPORTANT: The OpenAccess operating mode is set by default. In this operating
mode, access to the KVM extender is not protected by authentication. Information
on the operating modes can be found in chapter Operating modes of console modules
on page 71 ff.
NOTE: The connection between the computer module and the console module is
established automatically after the modules are started.