G&D VisionXS-IP-F-DP-UHR, Installation And Operation Manual

Page: 163 / 232

On-screen display
G&D VisionXS-IP-F-DP-UHR · 42
English
On-screen display
When starting the console module, information about the starting process as well as
the firmware versions and IDs of the connected modules are displayed in the monitor
of the console module.
Additionally, the
local hotkey
(default:
Alt
+
Num
) to open the local OSD of the console
module and the remote OSD
remote hotkey
(default:
Ctrl
+
Num
) to open the remote
OSD of the computer module are shown.
Basic operating of the on-screen display
The on-screen display (OSD) – just like the web application Config Panel , which is
described on the following – can be used to change the configuration of the KVM
extender.
The OSD can be opened by pressing a configured hotkey at the console module.
You can view and edit the settings of the KVM extender only in the remote OSD of
the computer module .
ADVICE: Press Pause to stop the process. Pressing Space continues the process.
NOTE: The actual configuration options by the user depend on the granted rights
(see Changing the user account rights on page 58 ff.).
IMPORTANT: The OpenAccess operating mode is set by default. In this operating
mode, access to the KVM extender is not protected by authentication. Information
on the operating modes can be found in chapter Operating modes of console modules
on page 71 ff.
NOTE: Use the
remote hotkey
(default:
Ctrl
+
Num
) at the console to open and config-
ure the remote OSD of the computer module and the
local hotkey
(default:
Alt
+
Num
)
to open and configure the local OSD of the console module.
During the starting process of the console module, the settings of both hotkeys are
shown (see
Starting process
on page 18).