Galil DMC-4040, User Manual

Page: 176 / 284

#B Label #B
TP AB Report A and B axes positions
WT 1000 Wait 1000 milliseconds
JP #B Jump to #B
EN End of program
#ININT Interrupt subroutine
MG "Interrupt has occurred" Displays the message
ST AB Stops motion on A and B axes
#LOOP;JP #LOOP,@IN[1]=0 Loop until Interrupt cleared
JG 15000,10000 Specify new speeds
WT 300 Wait 300 milliseconds
BG AB Begin motion on A and B axes
RI Return from Interrupt subroutine
Analog Inputs
The DMC-40x0 provides eight analog inputs. The value of these inputs in volts may be read using the @AN[n]
function where n is the analog input 1 through 8. The resolution of the Analog-to-Digital conversion is 12 bits (16-
bit ADC is available as an option). Analog inputs are useful for reading special sensors such as temperature, tension
or pressure.
The following examples show programs which cause the motor to follow an analog signal. The first example is a
point-to-point move. The second example shows a continuous move.
Example - Position Follower (Point-to-Point)
Objective - The motor must follow an analog signal. When the analog signal varies by 10V, motor must move
10000 counts.
Method: Read the analog input and command A to move to that point.
Instruction Interpretation
#POINTS Label
SP 7000 Speed
AC 80000;DC 80000 Acceleration
#LOOP
VP=@AN[1]*1000
Read and analog input, compute position
PA VP Command position
BGA Start motion
AMA After completion
JP #LOOP Repeat
EN End
Example - Position Follower (Continuous Move)
Method: Read the analog input, compute the commanded position and the position error. Command the motor to
run at a speed in proportions to the position error.
Instruction Interpretation
#CONT Label
AC 80000;DC 80000 Acceleration rate
JG 0 Start job mode
BGX Start motion
#LOOP
Chapter 7 Application Programming
•
167 DMC-40x0 User Manual