130
After setting the ruler, draw a straight line on the image, check the estimated value of the
straight line, and then compare this value with the value measured in the actual scene to
verify calibration accuracy. In case of major difference between the estimated value and
the actual one, fine-tune or reset parameters until the error requirement is met.
Procedure
Step 1 Select
Setting > Event > IVS > Global Setup
.
The
Global Setup
interface is displayed. See Figure 5-21.
Figure 5-21 Global setup of IVS
Step 2 Set parameters. See Table 5-5.
Table 5-5 Description of global setup (IVS) parameters
Parameter
Description
Anti-Disturb Enable A reserved function.
Sensitivity
Adjust the filter sensitivity. With higher value, it is easier to trigger an
alarm when low-contrast object and small object are captured, and the
false detection rate is higher.
Tracking Overlap
Rate
A reserved function.
Valid Tracking
Distance
A reserved function.
Valid Tracking Time A reserved function.
Step 3 Set calibration area and ruler.
1) Click
Add Calibration Area
and draw a calibration area in the image.
2) Select a calibration type and enter the actual length, and then click
Add Rulers
.
3) Draw one horizontal ruler and three vertical rulers in the calibration area.
Step 4 Click
Save
.
