M
CB
3
Installation Manual
Page 41
Check System Performance
Set up the rotating laser at a typical working range. Select the RPM of the laser to 600 RPM
or faster if available.
Mount the
MCR
receivers to the mast of the machine in a position to receive the
beam.
Select an On-grade deadband less than the jobsite tolerance. Typically 1/2 the tolerance is
the value used as a starting point.
Select the desired operating mode.
Fine tune the Valve Speed while working in typical material and operating conditions.
If the system is over correcting or too jumpy, decrease the valve speed setting.
If the system is not correcting fast enough or is sluggish, increase the valve speed setting.
If one side seems more reactive than the other side, the RH/LH Balance may be used to
correct this.
Environmental factors and laser set up can also affect system performance. Follow the set up
procedures for your laser. Ensure proper tripods are used for stable laser operation.
Changing the laser RPM, laser strike averaging, deadband, spool profile, valve speed, valve
balancing, or valve minimum corrections can affect system performance. System operation
should be rechecked after changing any of these parameters.
5.6
Technical Setup - Valve
