M
CB
3
Installation Manual
Page 23
Technical Setup
5.1
Technical Setup Menu
The Technical Setup Menu is used to configure the machine during initial installation.
It is recommended that the operator not have access to this menu.
To access the Technical Setup Menu, remove the access panel thumb screws and plate.
Move BAT 4 on the DIP switch into the ON position as shown.
The following screen appears:
The Technical Setup Menu consists of six sections:
System Setup
Valve Setup
Custom Setup
Troubleshoot
Store / Recall
Data Transfer
Each section has submenus. Menu availability and selection options will vary depending on
valve type selected, machine architecture, and model of sensors attached.
The menus are organized so that moving from the top to the bottom through the menus and
submenus provides the best order for system setup.
The menu is navigated by using the left or right multi-switch. Toggle the multi-switch down
to highlight the item below the current selection and to scroll down. Toggle the multi-switch
up to highlight the selection above the current selection and to scroll up. Press in the multi-
switch to enter the highlighted selection.
Values or options are selected by rotating the multi-switch for the corresponding left or right
side. An arrow and dotted box indicate the function must be entered to change values.
For numeric values, clockwise rotation increases the value; counterclockwise rotation
decreases the value.
Each section has an Exit function on the top and bottom level. To exit, scroll to the top or
bottom of the menu to highlight <Exit> and press in the multi-switch.
Configuring the
System Setup
and
Valve Setup
are generally required for all systems.
Modifying the
Custom Setup
is generally not required for most systems.
Technical Setup Menu
< Exit >
System Setup
Valve Setup
Custom Setup
