Furuno FA-150, Installation Manual

Page: 172 / 216

U
lstein Power & Control AS
This document and its content is the property of ULSTEIN. Non-
public information contained herein shall be treated as
Confidential Information. No use, copying, citation or publication
of this document or its content is permitted without prior written
consent from ULSTEIN. Any conflicts arising from unauthorized
use shall be governed by the laws of Norway.
File Name:
BRI-D32004-01II (D)
System Installation
Manual.doc Page:
Page 42 of
56
II. Start Setup.exe click the next button and finish until the istallation is complety. Then
click on Finish
Figure 4: Completing the setup
1.1.1. Starting Up the Ehernet Network
This section provides you with a step-by-step sample procedure for starting up the ETHERNET
network. You must perform three steps to start up the network:
• Determine the IP address of your PC and change it if required
• Assign an IP address to the SPS
• Test the ETHERNET link
The description of these work steps can be found in the corresponding following
sections.
2.2.2.1
Determining the IP address of your PC and changing it if required
The explanation below describes how you can determine the IP address currently set for your PC
and how you can change it if required.
I. To set up an ETHERNET link connect the ETHERNET port of your PC to one of the two
ETHERNET ports of the SPS using the cross-over cable provided with the system.
II. You can determine the IP address of your PC under: Start > Settings > Networks >
LAN
. Here, right click on the option
PROPERTIES
for the network you are currently
using (LAN X).
III. Then mark the item "Internet Protocol (TCP/IP)" in the popup list and confirm by
clicking
[PROPERTIES]
.