52
EN
Note
• If the connection test passes, you are
ready to use BD-Live, vTuner service or
network update function using the
Internet without making any extra
settings.
• If the connection test fails, you may
need to change the MAC address
settings on your router. You can check
the MAC address of this unit on
“Custom” screen.
• “Connection Test” is not available when
“Disable” is selected in “Network
Connection”.
Easy
Network settings are set to the following
settings initially. (In most cases, you can
connect to the Internet without making any
changes to the default settings.)
- IP Address Setting
Auto(DHCP)
- DNS Setting
Auto(DHCP)
- Proxy Setting
Do Not Use
- Connection Speed
Auto
- BD-Live Setting
Allow
If you want to set the network settings back
to the default settings as above (except
“BD-Live Setting”), follow the procedure
below.
1
Follow steps 1 to 4 in “Connection
Test” on page 51.
2
Use [
K
/
L
] to select “Easy”, then
press [OK].
• The unit will start the connection test
automatically and the test result will
appear right after the test finishes.
• After the connection test finishes, press
[OK]
to go to network status
confirmation screen.
3
Press [OK] to activate the network
settings and set the network
connection automatically. Press
[SETUP] to exit.
Note
• The setting of “BD-Live Setting” will not
be set back to the default, even if you
follow the procedure.
Custom
In the following cases, select “Custom” to set
each setting as necessary.
- When connection test failed with the
setting of “Easy”.
- When instructed by your Internet
service provider to make specific
settings in accordance with your
network environment.
