Fujitsu SPARC Enterprise T2000, Service Manual, Page: 60 / 174

3-20 SPARC Enterprise T2000 Server Service Manual • April 2007
Note – See
TABLE 3-11
for the ALOM CMT ASR commands.
removefru PS0|PS1
Indicates if it is okay to perform a hot-swap of a power supply. This
command does not perform any action, but it provides a warning if the
power supply should not be removed because the other power supply is
not enabled.
reset
[
-y
] [-c] Generates a hardware reset on the host server. The
-y
option enables you
to skip the confirmation question. The
-c
option executes a
console
command after completion of the
reset
command.
resetsc
[
-y
] Reboots the system controller. The
-y
option enables you to skip the
confirmation question.
setkeyswitch [-y] normal
|
stby
|
diag
|
locked
Sets the virtual keyswitch. The
-y
option enables you to skip the
confirmation question when setting the keyswitch to
stby
.
setlocator
[
on
|
off
] Turns the Locator LED on the server on or off.
showenvironment
Displays the environmental status of the host server. This information
includes system temperatures, power supply, front panel LED, hard drive,
fan, voltage, and current sensor status. See
Section 3.3.3, “Running the
showenvironment
Command” on page 3-22 .
showfaults
[
-v
] Displays current system faults. See Section 3.3.2, “Running the
showfaults
Command” on page 3-21 .
showfru
[
-g
lines ] [
-s
|
-d
]
[ FRU ]
Displays information about the FRUs in the server.
•
-g
lines specifies the number of lines to display before pausing the
output to the screen.
•
-s
displays static information about system FRUs (defaults to all FRUs,
unless one is specified).
•
-d
displays dynamic information about system FRUs (defaults to all
FRUs, unless one is specified). See Section 3.3.4, “Running the
showfru
Command” on page 3-25 .
showkeyswitch
Displays the status of the virtual keyswitch.
showlocator
Displays the current state of the Locator LED as either on or off.
showlogs
[
-b
lines |
-e
lines
|
-v]
[
-g
lines ] [
-p
logtype[r|p]]
]
Displays the history of all events logged in the ALOM CMT event buffers
(in RAM or the persistent buffers).
showplatform
[
-v
] Displays information about the host system’s hardware configuration, the
system serial number, and whether the hardware is providing service.
TABLE 3-8
Service-Related ALOM CMT Commands (Continued)
ALOM CMT Command Description