58
U41621-J-Z156-1-76
Configuring the Server
Preparation for Operation
©
c
o
gni
ta
s
. Ge
s
e
lls
c
h
ft
f
ü
r T
e
c
h
n
ik
-Do
k
u
m
ent
a
ti
o
n m
b
H
2
0
0
5
P
fad
: H
:\
G
S
\P
R
IM
E
R
G
Y
R
X
80
0 S
2
\B
A
\rx
8
00s
2u
s
.k
0
4
You can specify keyboard operating characteristics, e.g. whether the server
starts with the keyboard number lock on or off. You can enable the server to run
without a floppy disk drive, monitor or keyboard.
The server uses a startup sequence to determine the device from which the
operating system is booted. For example, you can define a startup sequence
that checks for a startable floppy disk in the floppy disk drive, then checks the
hard disk drive, and then checks a network adapter.
If the server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a Wake on LAN startup
sequence that checks for a startable CD-ROM in the DVD drive, then checks the
hard disk drive, and then checks a network adapter.
If you enable the boot fail count, die BIOS default setting will be restored after
three consecutive failures to find a boot record.
You also can enable a virus-warning test that checks for changes in the master
boot record at startup.
You can enable the use of a USB legacy keyboard in a DOS or System Setup
environment. If a keyboard is detected, the USB legacy operation will be
disabled.
This choice appears only on the full Configuration/Setup Utility main menu.
Advanced Setup
Select this choice to change values for advanced hardware features, such as
Memory Settings, CPU Options, PCI Slot/Device Information.
A message appears above the choices on this menu to alert you that the
system might malfunction if these options are configured incorrectly.
Follow the instructions on the screen carefully.
●
System Partition Visibility
Select this choice to identify if the System Partition is visible. To make the
System Partition visible, set this value to
Visible
. To make the System
Partition invisible, set this value to
Hidden
. Default value is
Hidden
.
This function is not operable for PRIMERGY RX800 S2.
i
i