Fujitsu ETERNUS AF S3 Series, Design Manual

Page: 160 / 204

●
Rear View
Figure 104 Rear View of a Controller Enclosure (ETERNUS AF250 S3)
1 1
2 4 5 3 5 3 2 3 4 6 6
7 7
3
PSU#0 PSU#1
CA#0
CM#0 CM#1
CA#1 CA#0 CA#1
1
Controllers (CM#0, CM#1)
(Refer to
"Controllers" (page 163) .)
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to
"■ PWC Ports" (page 166) .)
3
Host interfaces (CA#0, CA#1)
(Refer to
"■ Host Interfaces" (page 164) .)
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to
"■ Drive Interface Ports" (page 166) .)
5
RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 166) .)
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 166) .)
7
Power supply units (PSU#0, PSU#1)
(Refer to
"■ Power Supply Units" (page 167) .)
4. Hardware Configurations
Controller Enclosure
160 Design Guide