Fujitsu ETERNUS AF S3 Series, Design Manual

Page: 162 / 204

●
Rear View
Figure 107 Rear View of a Controller Enclosure (ETERNUS AF650 S3)
8 8
1 1
9 9
CPSU#0 CPSU#1
CA#0
CA#1 CA#0
CA#1
CA#2
CA#3 CA#2
CA#3
2 2
CM#0
CM#1
BUD#1 BUD#0
BUD#1 BUD#0
5 4 3 7 6
1
Controllers (CM#0, CM#1)
(Refer to
"Controllers" (page 163) .)
2
Host interfaces (CA#0, CA#1, CA#2, CA#3)
(Refer to
"■ Host Interfaces" (page 164) .)
3
RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 166) .)
4
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 166) .)
5
FST (LAN) port
A port that is dedicated for maintenance engineers. Customers must not use this port.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 166) .)
6
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to
"■ Drive Interface Ports" (page 166) .)
7
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to
"■ PWC Ports" (page 166) .)
8
Power supply units (CPSU#0, CPSU#1)
(Refer to
"■ Power Supply Units" (page 167) .)
9
BUD (BUD#0, BUD#1)
(Refer to
"■ BUD" (page 163) .)
4. Hardware Configurations
Controller Enclosure
162 Design Guide