Fujitsu ETERNUS AF S3 Series, Design Manual

Page: 159 / 204

2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
(Refer to
"■ PWC Ports" (page 166) .)
3
Host interfaces (CA#0, CA#1)
(Refer to
"■ Host Interfaces" (page 164) .)
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable
between enclosures.
(Refer to
"■ Drive Interface Ports" (page 166) .)
5
RMT (LAN) port
This port is used for connecting a LAN cable. Use this port to separate the network (such as for the
remote support) from the MNT port for operation management. This port uses an RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 166) .)
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an
RJ-45 connector.
(Refer to
"■ MNT Ports/RMT Ports/FST Ports" (page 166) .)
7
Power supply units (PSU#0, PSU#1)
(Refer to
"■ Power Supply Units" (page 167) .)
ETERNUS AF250 S3
The ETERNUS AF250 S3 controller enclosure contains drives installed in the front, and controllers and power
supply units in the rear.
●
Front View
Figure 103 Front View of a Controller Enclosure (ETERNUS AF250 S3)
Slo
t#0
Slo
t#1
Slo
t#2
Slo
t#3
Slo
t#4
Slo
t#5
Slo
t#6
Slo
t#7
Slo
t#8
Slo
t#9
Slo
t#10
Slo
t#11
Slo
t#12
Slo
t#13
Slo
t#14
Slo
t#15
Slo
t#16
Slo
t#17
Slo
t#18
Slo
t#19
Slo
t#20
Slo
t#21
Slo
t#22
Slo
t#23
1
3 3
2
1
Operation panel
An operation panel has LEDs, a Power switch, and a FUNCTION button.
2
2.5" drive
(Refer to
"■ Drives" (page 167) .)
3
Flange cover
4. Hardware Configurations
Controller Enclosure
159 Design Guide