Fujitsu 80, Scsi Logical Interface Specifications

Page: 273 / 310

5.2 INIT Error Recovery Methods (Recommended)
C141-C010 5-17
Table 5.3 Sense data error classification (3 of 4)
K* C* Q* Outline of Error L*
Recovery Method
(See Table 5.4.)
5 20 00 Invalid command operation code None 2
21 00 Logical block address out of range
24 00 Invalid field in CDB
25 00 Logical unit not supported
26 00 Invalid field in parameter list
There is an error in the command specification
contents.
5 3D 00 Invalid bits in IDENTIFY message None 3
90 00 Initiator's SCSI ID not identified
An error was detected in the SCSI protocol in the
command execution sequence.
6 29 xx Power on, reset, or BUS DEVICE RESET occurred None 14
The IDD was initialized by a Power on, RESET
condition or BUS DEVICE RESET message.
6 2A 01 Mode parameters changed None 21
The MODE SELECT parameters were changed
by another INIT.
6 2F 00 Commands cleared by another INIT None 25
Commands were cleared by another INIT.
6 3F 01 Microcode has been changed None 27
02 Changed operation definition
7 27 00 Write protected None 15
Access to a read protected or write protected.
B 03 xx Peripheral device write fault Need 12
11 xx Unrecovered read error
13 xx Sync byte not found for data field
14 xx Record not found
15 xx Mechanical positioning error
B 1B 00 Synchronous data transfer error offset
43 00 Message error Need 6
44 9D SPC detected Sync offset error interrupt.
45 80 Select/Reselect failure
47 00 SCSI parity error
48 00 INITIATOR DETECTED ERROR message received
49 00 Invalid message error
An unrecoverable SCSI related error occurred in
the command execution sequence.
* K: Sense Key C: Additional Sense Code
Q:
Additional Sense Code Qualifier
L: Logging Necessary? (shown in Section 5.2.3)