Fujitsu Siemens Computers FUTRO C, Operating Manual

Page: 61 / 70

System expansions
A26361-K679-Z120-1-7619, edition 2 53
Installing and removing a CompactFlash board
You can install a CompactFlash board instead of a hard disk.
The CompactFlash board has an IDE interface. The BIOS treats the CompactFlash module as
though it were an IDE hard disk.
i
If you want to operate a DVD/CD drive and a CompactFlash board in your device, then you
require an IDE cable with two IDE connections!
Installing a CompactFlash board
1
1
2
1
► Open the casing (see "Opening the casing").
► Place the CompactFlash board on the bracket
in the direction of the arrow (2).
► Screw the CompactFlash board with the three
screws (1) onto the carrier.
► Fasten the EasyChange rails to the bracket of
the CompactFlash board.
► Thread the connector of the power supply cable through and out of the bay and connect it to
the CompactFlash board.
i
The power supply has a 4 pin power supply connector. If you use an optical drive and a
CompactFlash board, you require an additional 4 pin power supply connector. Connect the
adapter cable provided to the serial ATA connector and to the power supply connection on
the CompactFlash board.
► Slide the CompactFlash board together with the bracket into the bay until it engages noticeably.
► Connect the power supply cable to the power supply connector.
► Connect the connector of the data cable to the CompactFlash board and to the mainboard.
► Close the casing (see "Closing the casing").