Fujitsu Siemens Computers FUTRO C, Operating Manual

Page: 20 / 70

Preparing for use
12 A26361-K679-Z120-1-7619, edition 2
Initial switch-on: Software will be installed
If the device is integrated into a network, the user and server details as well as the network protocol
are required during the software installation. Contact your network administrator if you have any
questions about these settings.
When you switch on your device for the first time, the supplied software is installed and configured.
Plan a reasonable amount of time for this, as this process must not be interrupted.
!
Once the installation has been started the device must not be switched off, unless the
installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
Otherwise the installation will not be performed correctly. If a fault occurs during the
installation, the contents of the hard disk must be completely restored.
You may require the Windows licence number during installation. This number is located on a sticker
on your device.
Switching on monitor and device
► Switch the monitor on (see the operating manual for the monitor).
► Switch the device on. To do this, follow the instructions below.
1
0 I
2
1 = Main switch
2 = ON/OFF switch 0 = Device is off
I = Device is ready-to-operate
► Switch the device ready-to-use with the main power switch (1) on the back panel.
► Press the ON/OFF switch (2) on the front of the casing in the direction of the arrow.
The power-on indicator lights green and the device is started.