FUJI CONTROLS CHECK MAN CM-5, Instruction Manual

Page: 30 / 34

−
26
−
them back to you.
d Display: The digital load display reads " ", the lower-limit display reads " ", and
all of the decimal points flash. The pair limit display for the upper and lower limits is "1."
Problem: The condition data
( , , )
that were set with in mode "03", may
be corrupt.
Remedy: Reenter the data using the membrane switches. If you do not, the system cannot operate
properly.
3. Malfunctions not mentioned above
The measurement device displays nothing. ・ Is the power cord plugged in?
・ Is the power switch turned ON?
The display values cannot be changed. ・ Is the cable connected properly to the 5 pin metal
connector on the tip of the load cell?
・ Is a reset signal input after a workpiece is evaluated?
The display does not continue to show a ・ Is the load measurement complete signal sensor
value. operating properly?
The system cannot reset the display. ・ Is the reset signal held active?
・ Is the wiring connected properly?
Comparison signals are not output. ・ Is the load measurement complete signal sensor
connected properly?
・ Is the load measurement complete signal sensor
connected to "b" type contacts?
・ Is the load measurement complete signal sensor
turned OFF after the reset signal is turned OFF?
<TROUBLESHOOTING CONTACT > TECHNICAL DEPARTMENT
Phone:03-3265-5437 Fax:03-3265-5430 E-mail:LES07537@nifty.ne.jp