FUJI CONTROLS CHECK MAN CM-5, Instruction Manual

Page: 11 / 34

Lead wire terminals
Metal connector for
load cell cable
Terminals are isolated. and
are connected inside and
of the device.
Terminals
９
１
２ ３ ８ ７ ６ ５ ４
２ ３
(There is no continuity between these terminals.)
Note:
Note:
Power supply
terminals for
Comparison signals
sensors
End
Power
Ground Reset
T o t e r m i n a l
１１
１２
１３ １４ １５
１６
COM
ＧＯ ＨＩ ＬＯ
５ ＶＤＣ
ＣＯＭ ＣＯＭ ＣＯＭ
ａ ａ ａ
ＣＯＭ ＣＯＭ
１０ １４ １２
１５
１６ １０
device
Terminal block on the
back of the measurement
−
7
−
External connection terminals and their functions
Terminals
①－②
: Reset (start) signal terminals
This signal is used to clear the display values, release the judgment signals, and initiate the automatic zero
function. Enter the signal after starting a press cycle. The signal can be entered any time, from 10 msec.
after starting the cycle until the cycle is complete. Since the system regards the change from an open to a
short circuit
(
OFF to ON
)
as a valid signal, make sure that the signal does not drop prematurely. Either
a no-voltage contact or an open collector signal are acceptable.
③－④－⑮
: Load measurement complete signal terminals
Terminal
⑮
is a 5 VDC + power source that is used for a photo sensor. When you will be using
no-voltage contacts, make sure to connect only terminals
③
and
④
. An open collector can also be used.
The system regards the change from a short to an open circuit
(
ON to OFF
)
as a valid timing input
signal. Before entering a reset signal, make sure to short the load measurement complete terminals. You
can check the current status of these terminals by watching the flickering of the judgment point indicator
on the front panel of the measuring device.