−
28
−
Panel cutout
(Tapped hole used for mounting the CM-5)
on the bottom
判定点
下限設定
上限設定
HI
GO
L O
P. NO
リ セッ ト
電 源
ＣＭ－５
kN
ＣＨＥ ＣＫ ＭＡ Ｎ
0 0 3 ( 3 k N { 3 0 6 k g f } )
0 3 ( 3 0 k N { 3 , 0 6 0 k g f } )
1 0 ( U ) ( 1 0 0 k N { 1 0 . 2 t f } )
2 0 ( U ) ( 2 0 0 k N { 2 0 . 3 9 t f } )
NOTE: The units shown in curly brackets"{ }" are for reference purposes only.
NOTE
：
the main housing.
When mounting the main housing by using the
tapped holes on the bottom, do not insert screws
that go deeper than 10 mm inside the housing.
cut the panel using the dimensions given below.
The numbers in parenthese( )
are for
MEASUREMENT DEVICE DIMENSION DRAWING
LOAD CELL MEASUREMENT DRAWINGS
Power cord (2-prong plug)
Metal connector for load cell cable
twisted pair cable, 2 meters
twisted pair cable, 2 meters
Load surface
Load surface
Load surface
Load surface
Load surface
Load surface
When you want to mount this housing on another panel,
Summary of Contents for CHECK MAN CM-5
Page 31: ...27...
