FUJI CONTROLS CHECK MAN CM-5, Instruction Manual

Page: 2 / 34

Thank you for purchasing our CHECK MAN/CM-5.
This instruction manual describes the basic functions and precautions in simple terms, so that even
people who are unfamiliar with this system can learn how to use it safely. Before using this unit,
read this manual thoroughly in order to get the maximum performance from the CHECK
MAN/CM-5. However, since this unit may be used in a wide variety of situations, this instruction
manual may not cover every case. If you are unclear about any detail, please feel free to contact us.
Make sure to store this manual in a handy place for future reference.
In this manual, the following types of messages are used to warn of potential
hazards:
DANGER
If you disregard this information, there is a likelihood of death or at least serious
injury.
WARNING
If you disregard this information, there is a possibility of death and a likelihood of
serious personal injury and/or damage to property.
CAUTION
If you disregard this information, there is a possibility of injury and a likelihood of
damage to the equipment or other property.
NOTE:
This contains special information that should be understood to operate the machine
effectively.
DANGER
The specified power is 100 VAC, 50/60 Hz. Never connect the unit to any other
voltage, since it is likely to cause a fire.
WARNING
This system is designed and manufactured to perform press fitting operations. If you
use this system for any other purpose, the functions and performance of the system
are not guaranteed and it may be dangerous.
WARNING
Do not place any voltage across the output relay terminals. If you do, the machine
will be damaged and the warranty will be void.
WARNING
Never touch the terminal block on the back of the main housing. Otherwise, you may
get an electrical shock.
CAUTION
Never modify, disassemble, or repair this system. If the machine needs to be serviced,
please contact us. We will not be responsible for malfunctions or other problems
caused by unauthorized service or repairs.
CAUTION
Always make sure to disconnect the power supply before touching the terminal block,
since you can get an electrical shock and damage the system.
CAUTION
Use this machine at ambient temperatures between 0 and 50 ℃ . Do not place the
system in direct sunlight and or near hot air. Use of the machine in conditions other
than those specified may cause a malfunction.
CAUTION
This system is designed on the assumption that it will be used inside Japan. If you use
the system outside Japan, please make sure you observe all of the safety regulations in
the country of use.
CAUTION
If you loan this machine to someone else, make sure to attach this instruction manual
to the machine.
CHECK MAN/CM-5 features
●
The CHECK MAN/CM-5 senses the load imposed by the press in press fitting operations and
compares it with the upper and lower limits that were specified by the operator. It decides whether the
press fitted workpiece is acceptable
(
GO
)
or unacceptable, because of too little or too much pressure
( HIGH-NG, LOW-NG ) . The result of the decision is shown on the digital load display and by the NG