Level the device with the assistance of the spirit
level (Fig. 8) by tightening the hexagon head
screws in the base evenly.
Fig. 8
Fig. 9
Fig. 10
•
Reassembly
◦
Ca
refully replace
the
inner protection
cylinder.
◦
Plug in the
heating
terminal plug.
◦
Put the casing onto the device –
aligning
the
embossings
with the
notches (Fig.
9
).
◦
Press down on the housing and turn it
clockwise towards “close”.
◦
Fasten the knurled screw.
◦
Insert the enclosed dirt trap spiral into the
funnel (Fig. 10).
The measuring edge of the upper
part of the housing is quite sharp.
There is a risk of cuts. It is therefore
recommended that on the measuring
edge not be pressed on and/or that
gloves are worn!
•
Inserting the dirt trap spiral
Insert the enclosed dirt trap spiral in the fun-
nel. The spiral should be held in such a way
that a complete turn in the anti-clockwise
direction is possible. Push the dirt trap spiral
in circular motion from above into the funnel
opening.
•
Removing the dirt trap spiral
Grab the dirt trap spiral in such a way that
a
complete turn in the anti-clockwise direction
is possible and pull it in a circular motion
towards the funnel opening.
Einsetzen
Entfernen
Insert
Remove
In order to protect the collecting vessel
the dirt trap spiral must be inserted into
the collecting funnel.
10
SDI-RAINE-HYDRO
USER MANUAL
700-SDI-RAINE-HYDRO Rev1 03 Mar 2021
Part# 21184
