Fronius TransSteel 2700c, Operating Instructions Manual

Page: 31 / 120

(2) "Parameter selection" button (left)
for selecting the following welding parameters and for changing parameters in
the Setup menu.
The relevant symbol lights up when a welding parameter is selected.
- Sheet thickness in mm or in.
If the welding current to be selected is not known it is sufficient to
enter the sheet thickness. The required welding current and any
other parameters marked with *) will then be adjusted automatic-
ally.
- Welding current in A *)
Before the start of welding, the device automatically displays a
standard value based on the programmed parameters. During
welding, the actual value is displayed.
- Wire feed speed in m/min or ipm *)
(3) Adjusting dial (right)
for changing the arc length correction, welding voltage and arc-force dynamic
parameters as well as changing parameters in the Setup menu
(4) Adjusting dial (left)
for changing the sheet thickness, welding current and wire feed speed para-
meters as well as changing parameters in the Setup menu
(5) "Save" buttons (Easy Job)
for saving up to 5 operating points
(6) "Process" button ***)
for selecting the welding process
- MANUAL - MIG/MAG standard manual welding
- SYNERGIC - MIG/MAG standard synergic welding
- STICK - manual metal arc welding
(7) "Mode" button
for selecting the operating mode
- 2 T - 2-step mode
- 4 T - 4-step mode
- S 4 T - Special 4-step mode
(8) "Shielding gas" button
for selecting the shielding gas to be used. Parameter SP is reserved for addi-
tional shielding gases.
The LED lights up next to the selected shielding gas.
(9) "Wire diameter" button
for selecting the wire diameter to be used. Parameter SP is reserved for addi-
tional wire diameters.
The LED lights up next to the selected wire diameter.
(10) "Material" button
for selecting the filler metal to be used. Parameter SP is reserved for additional
filler metals.
The LED lights up next to the selected filler metal.
31
EN