Fronius LaserHybrid MHP 360i LH, Operating Instructions Manual

Page: 67 / 112

67
EN-US
Setting Up Z-Axis
Loosen 2 x Allen screws size 5 mm (1)
Loosen 2 x Allen screws size 5 mm (2)
Set up the z-axis using the adjusting
screw and Allen key size 5 mm:
1 x turn equates to 1.0 mm
After setting up the z-axis, re-tighten the 4 x Allen screws size 5 mm (1) and (2):
Tightening torque for screw (1) = 6.5 Nm
Tightening torque for screw (2) = 10 Nm
NOTE! The z-axis is set up with the cover removed from the drive unit and with
the control box removed.
Re-fit the drive unit after setting up the control box and cover.
(1)
(1)
(2) (2)
1
1
2
2
1
2
3 3
3
1