Fronius LaserHybrid MHP 360i LH, Operating Instructions Manual

Page: 14 / 112

14
When handling coolants, observe the specifications on the safety data sheet. The coolant
safety data sheet is available from your service center or from the manufacturer's homep-
age.
Only use suitable load-carrying equipment from the manufacturer for transporting devices
by crane.
-
Attach chains or ropes to all designated suspension points on suitable load-carrying
equipment.
- Chains or ropes must be as close to perpendicular as possible.
- Remove the gas cylinder and wirefeeder (MIG/MAG and TIG devices).
Always use a suitable wirefeeder hoisting attachment with insulation on the crane for hoist-
ing the wirefeeder (MIG/MAG and TIG devices).
If the device is fitted with a carrier belt or handle, this should be used exclusively for trans-
portation by hand. The carrier belt is not suitable for transportation by crane, counterbal-
anced lift truck or other mechanical chain hoists.
All lifting equipment (belts, straps, chains, etc.) used in connection with the device or its
components must be checked regularly (e.g., for mechanical damage, corrosion, or chang-
es due to other environmental influences).
The test interval and scope must, as a minimum, comply with the respective valid national
standards and guidelines.
There is a risk of colorless, odorless shielding gas escaping without notice if an adapter is
used for the shielding gas connection. Use suitable Teflon tape to seal the thread of the
shielding gas connection adapter on the device side before installation.
Informal Safety
Measures The Operating Instructions must always be at hand wherever the LaserHybrid head is be-
ing used.
In addition to the Operating Instructions, all applicable local rules and regulations regarding
accident prevention and environmental protection must also be made available and be fol-
lowed.
All safety and danger notices on the LaserHybrid head must be kept in a legible state.
Safety Measures
at the Installation
Location The cell for the LaserHybrid welding process must meet the following requirements:
-
be light-proof in relation to surrounding rooms
- is shielded with at least 1 mm steel plate and/or approved laser protective glass to pro-
tect against UV and laser beams
- The laser welding process and the arc welding process must be stopped automatically
and immediately as soon as the cell is opened.
A toppling device can be deadly! Set up the device securely on an even, solid surface
-
A tilt angle of no more than 10° is permitted
Special regulations apply in areas at risk of fire or explosion
-
Follow the appropriate national and international regulations.
Use instructions and checks within the company to ensure that the vicinity of the workplace
is always clean and organized.
Only set up and operate the device in accordance with the degree of protection shown on
the rating plate.
When setting up the device, ensure an all-round clearance of 0.5 m (1 ft. 7.69 in.) so that
the cooling air can enter and leave unhindered.
Take care to ensure that the applicable national and regional guidelines and accident pre-
vention regulations are observed when transporting the device, especially guidelines con-
cerning hazards during transport and shipment.