Fronius DeltaSpot G2, Operating Instructions And Spare Parts List

Page: 53 / 68

53
EN
Replacing wearing parts and consumables
General
WARNING!
Work that is carried out incorrectly can cause serious injury or damage.
All work must be carried out by trained and qualified personnel in compliance with the rel-
evant safety regulations. Note the safety rules in the operating instructions.
IMPORTANT!
Check electrodes for wear and replace if necessary each time a new process tape is
loaded.
Instructions for
storing and load-
ing process tapes To guarantee that the process tapes remain in top quality condition, please note the follow-
ing recommended environmental conditions for storage:
-
Store process tapes only in the original packaging (vacuum packed)
- The temperature in the storage location should not exceed 35 °C (95 °F)
When loading a new process tape note the following:
-
Do not remove process tapes from their packaging until they are required
- Wear oil and grease-free gloves
- Dust and dirt free environment
- Do not touch adhesion points
Reloading the
process tape
CAUTION!
Risk of injury from springiness of spooled process tape.
To avoid injuries caused by the process tape springing back, hold the end of the tape firmly
when fitting it.
CAUTION!
Danger of injury from sharp-edged process tape.
Wear safety gloves when working with process tape.