Fronius DeltaSpot G2, Operating Instructions And Spare Parts List

Page: 11 / 68

11
EN
Specific hazards
If untrained operating personnel have access to the device, measures must be implement-
ed to ensure that the entire system is switched off for the duration of the work in this area
and that it is prevented from starting up again accidentally as the result, for example, of a
control fault.
In addition to these operating instructions, the robot manufacturer's safety rules must also
be observed.
Keep hands, hair, clothing and tools away from moving parts. For example:
-
Rollers
- Shafts
- Arms
Do not reach into rotating drive components.
Risk of entrapment!
Do not place hands or other body parts between the welding electrodes or other moving
parts.
Risk of cutting!
Wear safety gloves when handling sharp objects and process tape.
Covers and side panels may only be opened or removed for as long as maintenance or
repair work is being carried out.
During operation:
-
Ensure that all covers are closed and all side panels are fitted properly.
- Keep all covers and side panels closed.
Never touch the workpiece, electrodes or process tape during or after welding - risk of
burns.
Welding residue may be ejected from cooling workpieces. The specified protective equip-
ment must therefore also be worn when reworking workpieces, and steps must be taken
to ensure that other people are also adequately protected.
Welding electrodes, process tape and other parts with a high operating temperature must
be allowed to cool down before handling.
Special provisions apply in areas at risk of fire or explosion
- observe relevant national and international regulations.
Risk of scalding from escaping coolant. Switch off cooling unit before disconnecting cool-
ant flow or return lines.
Use only suitable load-carrying equipment supplied by the manufacturer when transporting
devices by crane.
-
Hook chains or ropes onto all suspension points provided on the load-carrying equip-
ment.
- Chains and ropes must be at the smallest angle possible to the vertical.
All lifting accessories (straps, handles, chains, etc.) used in connection with the device or
its components must be tested regularly (e.g. for mechanical damage, corrosion or chang-
es caused by other environmental factors).
The testing interval and scope of testing must comply with applicable national standards
and directives as a minimum.
Safety measures
at the installation
location and dur-
ing transport A device that topples over can cause life-threatening injuries. Place the device on a solid,
level surface.