Fronius DeltaSpot G2, Operating Instructions And Spare Parts List

Page: 34 / 68

34
(5) Start homing button
for defining the home position for the main drive and compensation drive (X-gun
and C-gun) before start-up
(6) Reset button
for resetting a fault that has occurred
(7) Error LED
lights up in the following situations:
-
during commissioning if the home position has not yet been defined
- if faults arise during an ongoing operation
(8) Homing position LED
lights up as soon as the homing position is defined
(9) Welding current switch
- No Welding: after pressing the RUN button (32), the welding program with the
number 0 (X-gun and C-gun) will be simulated without current but with a prede-
fined force profile.
- Welding: after pressing the RUN button (32), welding will begin using a welding
program with predefined parameters
(10) Left/right enabling buttons
IMPORTANT! Always check the enabling button before switching on the remote
control. Unless one of the enabling buttons is pressed at the same time, the con-
trols on the front of the remote control will not trigger any movements.
None of the specified controls on the front of the remote control will work unless
one of the two enabling buttons on the back is pressed at the same time. If neither
of the enabling buttons is pressed while in manual mode, the safety circuit will be
broken and the drives will stop.