Fronius DeltaSpot G2, Operating Instructions And Spare Parts List

Page: 12 / 68

12
Special regulations apply in rooms at risk of fire or explosion.
-
Observe relevant national and international regulations.
Use internal work instructions and checks to ensure that the workplace environment is al-
ways clean and clearly laid out.
Only set up and operate the device in accordance with the degree of protection shown on
the rating plate.
When setting up the gun control, ensure there is an all-round clearance of 0.5 m (1.6 ft.)
so that cooling air can flow in and out unhindered.
When transporting the device, observe the relevant national and local guidelines and ac-
cident prevention regulations. This applies especially to guidelines regarding the risks aris-
ing during transport.
Before transporting the device, allow coolant to drain completely and detach components.
After transporting the device, the device must be visually inspected for damage before
commissioning. Any damage must be repaired by trained service technicians before com-
missioning the device.
Safety measures
in normal opera-
tion Only operate the device if all of its protection devices are fully functional. If the protection
devices are not in full working order, there is a risk of
-
injury or death to the operator or a third party,
- damage to the device and other material assets belonging to the operator,
- inefficient operation of the device.
Any safety devices that are not functioning properly must be repaired before switching on
the device.
Never bypass or disable protection devices.
Before switching on the device, ensure that no one is likely to be endangered.
-
Check the device at least once a week for obvious damage and the proper functioning
of safety devices.
- Use only appropriate coolant. Note the information provided by the manufacturer of
the cooling system.
- If damage results from using a different coolant the manufacturer accepts no liability.
In addition, all warranty claims are forfeited.
Commissioning,
maintenance and
repair It is impossible to guarantee that bought-in parts are designed and manufactured to meet
the demands made of them, or that they satisfy safety requirements.
-
Use only original spare and wearing parts (also applies to standard parts).
- Do not carry out any modifications, alterations, etc. to the device without the manufac-
turer's consent.
- Components that are not in perfect condition must be replaced immediately.
- When ordering, please give the exact designation and part number as shown in the
spare parts list, as well as the serial number of your device.
The housing screws provide the ground conductor connection for earthing the housing
parts.
Only use original housing screws in the correct number and tightened to the specified
torque.
Safety inspection The manufacturer recommends that a safety inspection of the device is performed at least
once every 12 months.