Fronius DeltaSpot G2, Operating Instructions And Spare Parts List

Page: 33 / 68

33
EN
Remote control
RemoteControl
Pro
WARNING!
Machines that start up automatically can cause serious injury and damage.
In addition to these operating instructions, the safety rules issued by the manufacturer of
the robot and welding systems must also be observed. For your personal safety, ensure
that all protective measures have been taken and will remain in place for the duration of
your stay within the working area of the robot.
The RemoteControl Pro is for manually controlling the spot welding gun. It is used to
-
define a homing position after commissioning the system
- reload process tape
- manually spot weld within preset parameters
- manually push in electrodes after replacement
- reset faults that have occurred
None of the controls on the front of the remote control will work unless one of the two en-
abling buttons on the back is pressed at the same time. If neither of the enabling buttons
is pressed while in manual mode, the safety circuit will be broken and the drives will stop.
(1) Open and close spot welding gun switch
for manually opening and closing the spot welding gun
(2) Process tape forward or backward switch (moving gun arm)
for manually feeding the process tape
(3) Process tape forward or backward switch (fixed gun arm)
for manually feeding the process tape
(4) RUN button
for starting the welding process. In manual mode, program 0 is automatically start-
ed on the spot welding gun.
NOTE!
Risk of premature termination of the welding process.
Hold the RUN button down until the end of the welding process.
RemoteControl Pro
NO WELDING
WELDING
RESET REFERENCE RUN
OK
(1) (2) (3)
(6)
(7)
(8)
(9)
(5) (4)
(10) (10)