Fronius 10.0-3 480, Service Manual

Page: 104 / 180

104
431 Power stage set is in boot
mode 1. Power stage set will be pro-
grammed by the Recerbo auto-
matically 1. Automatically corrected
2. Power stage set can not be
programmed automatically 2. Software update
3. Filter board defective 3. Change Recerbo
4. Recerbo defective 4. Change filter board
5. Power stage set defective 5. Change AC board
432 Consistent error in power
stage set management 1. Power stage set could not
communicate with the Recerbo 1. Restart inverter or do a soft-
ware update
2. Power stage set defective 2. Change AC board
3. Recerbo defective 3. Change Recerbo
433 Allocation error of dynamic
addresses 1. Power stage set could not
communicate with the Recerbo 1. Restart inverter or do a soft-
ware update
2. Power stage set defective 2. Change AC board
3. Recerbo defective 3. Change Recerbo
436 Problem while error trans-
mitting of the power stage
set 1. Power stage set could not
communicate with the Recerbo 1. Restart inverter or do a soft-
ware update
2. Power stage set defective 2. Change AC board
3. Recerbo defective 3. Change Recerbo
437 Problem with the internal
error handling 1. Power stage set could not
communicate with the Recerbo 1. Restart inverter or do a soft-
ware update
2. Power stage set defective 2. Change AC board
3. Recerbo defective 3. Change Recerbo
438 Problem while error trans-
mitting from power stage
set to Recerbo 1. Power stage set could not
communicate with the Recerbo 1. Restart inverter or do a soft-
ware update
2. Power stage set defective 2. Change AC board
3. Recerbo defective 3. Change Recerbo
445 Country setup information
faulty 1. Country setup information
faulty 1. Do a software update and
reload country setup fromsetup
menu
2. Old software (e.g after print
exchange) 2. Do a software update and
reload country setup fromsetup
menu
3. Impossible manual settings
in service menu 3. Check settings
4. Recerbo defective 4. Change Recerbo
447 Isolation failure detected 1. PV generator grounded 1. Use only ungrounded mod-
ules
2. PV generator grounding er-
ror 2. Check PV generator
3. Measuring circuit on power
stack defect 3. Change DC board. After-
wards if necessary AC board
448 Neutral wire fault 1. No neutral wire detected 1. Check wiring
2. Wrong setup 2. Check country setup
3. Bad contact: wall bracket <-
> inverter 3. Check AC wall bracket
screws
4. Filter board defective 4. Change filter board
Code Description Behaviour Remedy