27
Stand/Update
: 01.2019
5.4.1.2
Operator pass
The main window shows the entered operator, if any, at the bottom right. If no
operator pass has been activated, the window remains unchanged.
The operator cannot be edited manually (via key presses). To register a new
operator, you must read in a new operator pass (see Section 5.2.1).
5.4.1.3
Serial number
Press the (ID DATA) function key. The serial number of the executed fusions
appear on the display. This number is assigned automatically by the device and
cannot be changed. This serial number is assigned to each of the activated
commission numbers.
5.4.1.4
Seam Number
1. Press the (ID DATA) function key .
2. Use the “Down” direction key to select “Seam Number”.
3. Press the (Input/Emergency Input) function key.
4. Enter each of the numbers from the first to the last using the direction keys
on the virtual keypad. When finished, press OK.
5. Press the (Confirm) function key to save the entered numbers, the (Cancel)
function key to abort the input, or the (Backspace) function key to delete
preceding numbers.
6. A previously assigned seam number can be edited on the virtual keypad.
7. Press the (OK) function key or the STOP key to close the menu.
5.4.1.5
GPS 1 - 3
The coordinates/location of the fusion (GPS 1, GPS 2, GPS 3) can be entered in
the menu “GPS 1–3”. The GPS data are made up of three input fields: GPS 1 for
the geographical longitude, GPS 2 for the geographical latitude, and GPS 3 for
the altitude above sea level. GPS 1 can take a string of thirteen user definable
alphanumerics, GPS 2 twelve, and GPS 3 ten.
INFORMATION
A corresponding device is needed to determine the GPS data!
