freightliner NEW CASCADIA 2016, Driver Manual

Page: 189 / 207

2. Inspect the exterior surfaces of brake chambers
for damage. Make sure that breather holes are
open and free of debris.
NOTE: Do not route air brake lines on top of
anything likely to be stepped on.
3.
Inspect air brake lines for dents, swelling, kinks,
twisting, abrasion, and damage, especially near
moving parts.
4. Inspect flex air lines for deterioration or signs of
abrasion.
5. Inspect for cracked, worn, or oil-contaminated
brake linings and brake drums (or rotors).
6. Check the thickness of the brake linings. Re-
place brake linings on all brake assemblies on
the axle if any brake linings are worn to less than
approximately 1/4 inch (6.4 mm) at the thinnest
point.
Saddle Tank Areas Inspection
WARNING
When draining the air reservoir, do not look into
the air jets or direct them toward anyone. Dirt or
sludge particles may be in the airstream and
could cause injury.
NOTICE
If the water drained from the air reservoirs is
cloudy or oily, it may indicate a problem with the
compressor. If oil is allowed to contaminate the
air dryer, it will not remove the water from the air
brake system, which could adversely affect brak-
ing.
1. Drain the brake system air reservoirs (reservoirs
with automatic drain valves only).
NOTE: Battery locations vary between vehicles.
2. Inspect the batteries.
WARNING
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. To prevent possible per-
sonal injury, always wash your hands after han-
dling battery parts and related accessories.
2.1 Remove the battery box cover and inspect
all visible battery cables for loose wiring or
damage.
2.2
Check that the battery hold-down is se-
cure.
IMPORTANT: Aerodynamic components de-
crease drag force as a vehicle moves, thereby
improving fuel efficiency. If replacement of an
aerodynamic component is necessary, replace-
ment components must meet or exceed the
drag reduction performance of the originally in-
stalled component in order to maintain compli-
ance with greenhouse gas and fuel efficiency
regulations (GHG14).
3. Inspect the following aerodynamic components, if
equipped, for structural damage, cracks, or wear.
•
Chassis fairings
•
Roof fairing/deflector
•
Side skirts
•
Cab/sleeper extenders
•
Battery access cover
Engine Compartment Inspection and
Adjustments
IMPORTANT: If replacement of the hood or
bumper is necessary, the replacement compo-
nent must meet or exceed the drag reduction
performance of the originally installed item in
order to maintain compliance with greenhouse
gas and fuel efficiency regulations (GHG14).
1. Inspect the bumper and hood for structural dam-
age, cracks, or wear.
2. Check the hydraulic clutch reservoir, if equipped.
If necessary, add DOT 4 brake fluid.
3. Inspect the radiator and heater hoses, including
the clamps and support brackets.
3.1 Inspect the radiator and charge air cooler
for damage and accumulated debris.
Straighten bent or damaged fins to permit
airflow across all areas of the cores.
NOTE: When traveling through areas of high
insect concentration, it may be necessary to
clean the exterior of the radiator or the
Pre- and Post-Trip Inspections and Maintenance
23.11