7
4
4. Slide the Upright Screw Cover (47) onto the
Upright (3).
Make sure that the Upright Screw
Cover is oriented as shown.
Then, slide the
Upright Screw Cover upward toward the top of
the Upright.
Have a second person hold the Upright (3) near
the Frame (1). Locate the wire tie (see the inset
drawing) in the Upright. Tie the lower end of the
wire tie to the frame wires (A). Next, pull the
upper end of the wire tie upward out of the top
of the Upright. Then, untie and discard the wire
tie.
Tip: Use a piece of tape or an elastic
band to keep the ends of the frame wires
from falling into the Upright.
Tip: Avoid pinching the frame wires (A).
Slide
the Upright (3) onto the Frame (1). Attach the
Upright with four M8 x 20mm Flat Head Screws
(41).
Then, slide the Upright Screw Cover (47) down-
ward to the bottom of the Upright (3).
4
5
5. While a second person holds the Console (4)
near the Upright (3), connect the wires on the
Console to the frame wires (A) and the frame
pulse wires (B).
Note: Some of the wires are for the optional
Workout TV (see page 10).
Tip: Avoid pinching the wires.
Attach the
Console (4) to the Upright (3) with four M8 x
20mm Screws (44).
Avoid pinching
the wires
Wire Tie
A
A
41
41
47
44
1
3
3
Avoid pinching
the wires
6.
Make sure that all parts of the exercise bike are properly tightened.
Note: Some hardware may be left
over after assembly is completed. To protect the floor or carpet from damage, place a mat under the exercise
bike.
B
A
