FP S-Compact BB / LAN
42
7
Operation with USB memory stick
A USB memory stick (max. 32 GB) can be used for the following tasks:
– Importing a configuration via ‘config.txt’ file
– Firmware update via a ‘Tixi.Gate8_FW.tar.gz’ file
– Debug recordings via a ‘debtrace.txt’ file
– Archiving of log data via the ‘WriteFile’ command.
The USB stick should be formatted with the FAT32 file system. Only one partition is
permitted on the USB stick. Use a USB stick with a short overall length, which has suf-
ficient space in the FP S-Compact.
Inserting the USB memory stick
Disconnect FP S-Compact from the power supply.
The ‘Power’ LED is OFF.
Unscrew the housing cover (see page 19).
Keep the housing cover and the four screws in a safe place.
Insert the USB memory stick formatted to FAT32 (max. 32 GB)
into the USB port.
Fasten the housing cover to the housing with the four
fastening screws. Tighten the fastening screws with a torque
of 0.7 Nm to 1 Nm (0.52 ft lb to 0.73 ft lb).
Re-establish the power supply.
After restarting the device, the USB memory stick is
automatically detected.
The ‘WiFi’ LED illuminates steadily green if the USB memory
stick is mounted.
You can also insert USB memory sticks with a live power supply.
Summary of Contents for FP S-Compact BB
