FP S-Compact BB / LAN
18
Fastening
The FP S-Compact is designed for wall mounting or mounting
on a top-hat rail. Mounting material is optionally available from
FP InovoLabs.
Note down the serial number of the device located on the serial
number plate. After mounting the device on the wall, the serial
number plate is no longer visible.
Use the two fastening screws provided (EJOT PT K40x10
WN 1452, Tool: T20) and the holes on the back provided
for these.
Rear of the
FP S-Compact
Damage to the device and loss of the IP65 protection rating
by screwing the fastening screws in too deep!
Do not screw the fastening screws deeper than 8 mm (0.31")
into the housing.
Fastening screws
for wall mounting or
top-hat rail mounting
Serial number plate
Summary of Contents for FP S-Compact BB
