FP InovoLabs FP S-Compact BB, Installation And Safety, Page: 29 / 60

Installing the FP S-Compact
29
Step 11: Putting into operation
When all installation steps are completed, the FP S-Compact
can be put into operation.

Switch on the supply voltage.
Self-test After applying the operating voltage, the device carries out an
extensive self-test. The LEDs indicate the status.
When the self-test is completed, the yellow ‘Power’ LED
lights up.
FP S-Compact must still be configured for operation. Software
tools for this can be purchased from FP InovoLabs.
Power Dat / Proc Line LAN Mode Remarks
Load firmware,
check checksum
+
(flashes)
Unpacking of the firmware
+ Launching the Kernel
Launching the Linux application
All LEDs turned off for approx. 5 s
(flashes) (flashes)(flashes)
Multiple simultaneous flashing of
Data Out / Line / LAN
Self-test completed