Installing the FP S-Compact
25
Step 8: Connecting to the power supply
Removing the protective cover
The protective cover is fastened in place with a snap hook on
both the left and right sides.
Removing the
protective cover
First loosen the fastening on the right side: Insert a slotted
screwdriver into the ‘OPEN 1’ opening and press the snap
hooks gently outwards (towards the arrow).
Danger to life through electric shock!
There is danger to life when touching live parts.
Disconnect the cables to which the device is connected from
the power supply and secure them against being switched on
again.
Check that the cables to which the device is connected are
voltage-free.
Do not connect the power supply until all other installation
work has been completed.
Danger to life through electric shock when operating on an
unsuitable electrical system!
Connect the device only to a properly installed electrical system
that has an easily accessible, all-pole (L,N) disconnect device
equipped with a minimum contact spacing of 3 mm (0.12").
Snap hook
Protective cover
Snap hook
Slotted screwdriver
Summary of Contents for FP S-Compact BB
