December 2008
© 2008 Foundry Networks, Inc.
3 - 1
Chapter 3
Installing the Chassis
This chapter describes hardware installation tasks for the FastIron X Series chassis devices.
WARNING:
The procedures in this manual are for qualified service personnel.
NOTE:
Information about configuring IP addresses and connecting a FastIron X Series chassis device to other
network devices is covered in the chapter “Connecting Network Devices and Checking Connectivity” on page 4-1.
Summary of Installation Tasks
Table 3.1 lists the tasks you must perform to install your FSX Switch and where to access detailed information that
allows you to perform each task.
Table 3.1: FSX Hardware Installation Tasks
Task
Number
Task
Where to Find More Information
1
Unpack the chassis, and verify that all contents
are present.
“Unpacking a System” on page 3-2
2
Review the installation cautions and warnings.
“Installation Precautions” on page 3-3
3
Ensure that the physical environment that will
host the chassis has proper cabling and
ventilation.
“Preparing the Installation Site” on
page 3-4
4
The FSX and FSX 800 chassis ships with extra
screws installed in the right side of the chassis.
These screws secure the fan tray assembly,
protecting it from damage during shipment. You
must remove these screws before installing the
chassis.
“Removing Extra Shipment Screws
(FSX and FSX 800 only)” on page 3-
5
