Maintaining the Hardware
December 2008
© 2008 Foundry Networks, Inc.
7 - 33
3.
Remove the fan from the chassis by pulling the enclosure toward you as shown in Figure 7.18. Pulling the
enclosure unseats the fan connector from a chassis connector.
WARNING:
Be careful not to accidentally insert your fingers into the fan while removing it from the chassis. The
fan may still be spinning at a high speed.
Figure 7.18
Removing a Fan Assembly from the FSX 1600-ANR Chassis
4.
Insert the new fan assembly into the fan slot and push the enclosure in until the face plate is flush with the
chassis. Pushing the enclosure in seats the fan connector with the chassis connector.
5.
Secure the fan to the chassis by tightening the two captive screws.
6.
Access the CLI, and enter the
show chassis
command to verify that both fans are operating normally.
Upgrading the Device to Run Layer 3 Software
You can upgrade the FastIron X Series chassis to run Layer 3 code. To do so, follow the instructions In Appendix
A, “Layer 3 Upgrade Procedures” on page A-1.
Fan A
Fan B
